Scotsman NM650 Instrukcja Operatora Pobierz pdf (Strona 18)

91773

CLEANING INSTRUCTIONS

WARNING: DISCONNECT ALL POWER BEFORE CLEANING. Do not use metal scrapers,

sharp objects or abrasives on the ice storage hopper, top cover and the agitator disk, as

damage may result. Do not use solvents or other cleaning agents, as they may attack the

plastic material.

DISPENSER (All Models)

1. Clean the ice storage hopper at least once a month.

2. Remove center screw and washer on agitator disk and lift off the agitator and the agitator disk assembly.

Wash and rinse them thoroughly.

3. Wash down the inside of the hopper and top cover with a mild detergent solution and rinse thoroughly to

remove all traces of detergent.

4. Replace the agitator.

5. Sanitize the inside of the hopper and agitator with a solution of 1 ounce of household bleach in 2 gallons of

water (200 PPM).

6. Replace the agitator disk. Sanitize as described in Step 5. Be sure center screw and washer are replaced

and screw is tight.

7. Clean and sanitize the ice chute as described below:

A. Enter the Clean Mode of the ice portion control by pressing the decrease and increase buttons at the

same time. The indicator light will alternately display red/amber.

B. To empty the ice from the ice chute, press any of the size buttons. The ice gate will then open to allow

the ice chute to empty. The ice gate will automatically close after the ice chute as been emptied.

C. Remove the 2 thumbscrews attaching the upper service panel and remove the panel.

D. Remove the 2 thumbscrews attaching the ice chute strap and remove the strap

E. Remove the 4 thumbscrews that secure the ice tube to the ice hopper. Rmove the ice chute and gate

cover. Power to the ice portion control and beverage valves will be interrupted while the ice chute is

removed.

F. Wash ice chute, gate slide and gate cover in detergent soap solution. Then rinse thoroughly with plain

water. Sanitize as described in Step 5.

G. Replace components removed for cleaning in reverse order of removal.

H. Portion control will automatically return to Normal Operating Mode (green Indicator) after the ice chute

is replaced.

COLD PLATE (--BC Models)

1. Carefully remove screws holding beverage faucet panel and bring forward.

2. Slide the cold plate cover back. (Remove shipping tape and discard.)

3. Remove any debris from the drain trough and spring. Check that drain hole is not clogged.

4. Wash down the inside of the cold plate, tray and cover with a mild detergent solution and rinse. A small,

long-handled brush will be found helpful in reaching the corners.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24

Brak uwag

Scotsman NM650 Instrukcja Operatora Strona 18